VICTRON ENERGY MULTIPLUS COMPACT 12/2000/80-30 VE.BUS – CMP122200000
VICTRON ENERGY MULTIPLUS COMPACT 12/2000/80-30 VE.BUS
Multiplus compact 12/2000/80-30 The main output has “no-break” functionality. The MultiPlus will take over the supply to the connected loads in the event of a grid failure or when shore/generator power is disconnected. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment continue to operate without disruption. The second output is live only when AC is available on the input of the MultiPlus. Loads that will not discharge the battery, a water heater for example, can be connected to this output (second output available on models rated at 3 kVA and more).
Virtually unlimited power thanks to parallel operation
Up to 6 Multis will operate in parallel to achieve higher power output. Six 24/5000/120 units, for example, will provide 25 kW / 30 kVA output power with 720 Amps charging capacity. Three phase capability in addition to parallel connection, three units of the same model can be configured for three phase output. And that’s not all. Because up to 6 sets of three units can be parallel connected for a huge 75 kW / 90 kVA inverter and more than 2000 Amps charging capacity.
PowerControl – Dealing with limited generator, shore side or grid power
The MultiPlus is also a very powerful battery charger. It therefore draws a lot of current from the generator or shore-side supply (nearly 10 A per 5 kVA Multi at 230 VAC). With the Multi Control-Panel, a maximum generator or shore current can be set. The MultiPlus will then take into account other AC loads and use whatever is surplus for charging. Thus preventing the generator or shore supply from being overloaded.
PowerAssist – Boosting the capacity of shore or generator power
This feature takes the principle of PowerControl to a further dimension because it allows the MultiPlus to supplement the capacity of the alternative source. Where peak power is so often required only for a limited period, the MultiPlus will ensure that insufficient shore or generator power is immediately compensated for by power from the battery. When the load reduces, the spare power is used to recharge the battery.
Solar energy: AC power available even during a grid failure
The MultiPlus can be used in off grid as well as grid connected PV and other alternative energy systems. Loss of mains detection software is available.
- In case of a stand-alone application, if settings have to be changed, this can be done in a matter of minutes with a DIP switch setting procedure.
- Parallel and three phase applications can be configured with VE.Bus Quick Configure and VE.Bus System Configurator software.
|Manufacturer Part Number
|Transfer Switch (A)
|Cont. Output Power at 25°C (VA)
|Peak Power (W)
|Zero Load Power (W)
|Charge Current House Battery (A)
|Charge Current Starter Battery (A)
|Battery Temperature Sensor
|H520 x W255 x D125mm
|Country of Manufacture
For more information on this product please view the link below: